The Revvity OM500 MicroTip Probe, 1/16 Inch, 1.6 mm (060-062K), is a thin, high-intensity titanium probe for processing sample volumes from 200 µL to 5 mL with the OM500 Ultrasonic Homogenizer. The microtip screws into the threaded end of the standard 060-500 1/2 inch probe. It is designed for short bursts of small-volume ultrasonic sample processing.
Key Features
- Small-volume processing from 200 µL to 5 mL, matching the manufacturer-specified range for this microtip size
- Fine 1.6 mm probe diameter, equivalent to a 1/16 inch microtip configuration
- Thin, high-intensity design, developed for ultrasonic processing of small liquid samples
- Titanium construction, providing the manufacturer-specified probe material for compatible sonication workflows
- Dedicated OM500 compatibility, designed for the Revvity OM500 Ultrasonic Homogenizer
- Threaded probe attachment, screwing into the end of the standard 060-500 1/2 inch probe
- Short-burst operation, recommended because small samples and the microtip can heat rapidly during continuous use
- Pulse-mode processing guidance, with chilled samples recommended for optimum results
Note: Processing volumes below 200 µL are not recommended because the microtip cannot be properly submerged, which may cause foaming, aerosols and overheating. The standard 060-500 probe is required for attachment. For research use only and not for use in diagnostic procedures.
Benefits
- Enables ultrasonic processing of samples as small as 200 µL using the compatible OM500 system.
- Provides a dedicated microtip option for workflows that cannot use larger standard probe diameters.
- Connects to the standard 060-500 probe, allowing the OM500 setup to be configured for smaller sample volumes.
- Supports temperature-conscious processing through short bursts, pulse mode and chilled sample preparation.
- Helps reduce foaming, aerosol formation and overheating when operated within the recommended volume range.
Why Choose the Revvity OM500 MicroTip Probe, 1/16 Inch, 1.6 mm (060-062K)?
The Revvity 060-062K provides a manufacturer-specified titanium microtip for processing 200 µL to 5 mL samples with the OM500 Ultrasonic Homogenizer. Its 1.6 mm diameter and threaded connection to the standard 060-500 probe support small-volume sonication when used with the recommended pulse and cooling practices. John Morris Group supplies Revvity sonication equipment and compatible ultrasonic probes throughout Australia.
